ZALMAN HD503 Especificaciones

English

8HD500 SeriesmATX Standoff(3) ODD InstallationInstall the ODD into an available slot in the ODD Chassis and fasten with ODD Bolts. TipIf the mothe

English9HD500 SeriesTo remove Handle, pull upwards while pressing the Hook Button.Use the Hand Screws to attach the Handle to the HDD.Push the HDD int

10HD500 SeriesInsert the SSD in the SSD Bracket and fasten with SSD Bolts. Reattach the HDD handle to the SSD Bracket.Push the SSD into the slot until

2English11HD500 SeriesIf the case is frequently transported, please fasten the ODD Chassis (Top) and HDD Chassis (Bottom) before use. Tip(6) ODD/

12HD500 Series(7) Hot Swap Bay Installation1) HDD Tray Removal2) 3.5” HDD Installation‘Open’ the Hot Swap Tray by pressing the Hot Swap Tray’s Hooks l

English13HD500 SeriesAlign the HDD’s screw holes with the Hot Swap Trays Fixing Pins, then ‘close’ the Hot Swap Tray by pushing in the protruded secti

14HD500 Series3) Hot Swap Cable ConnectionS-ATA Port4 Pin Power Port (HDD)4-Pin Power Port (Fan)3-Pin FanConnectorFan Speed Control Switch (Up: 12V/ D

English15HD500 Series2) DFSTN and Media Controller Cable Connections [HD503]1) Front Panel I/O Cable Connections [HD501, HD503]e-SATA USB HD Audio AC’

616HD500 SeriesOptional Fan InstallationUnfasten the Fixing Bolts and press the Hooks towards each other to pull the Side Panels off.Install the 2 X 1

7English17HD500 SeriesRecommended Use1) Installation Location2) Cable RoutingFor adequate air flow, please install the system in a well ventilated are

18HD500 SeriesMEMO

1English1HD500 Series(1) Please read this manual thoroughly prior to installation.(2) Before installing, check the components and condition of the p

22HD500 SeriesModels HD501 HD503Enclosure Type HTPCDimensions(W×H×D)450 × 170 × 455mm (17.6” X 6.8” X 17.9”)WeightMain Unit: 8kg(17.6lb) / with packag

3English3HD500 SeriesComponents(1) Main UnitTop PanelTop PanelHDD ChassisHDD ChassisODD ChassisODD ChassisMain ChassisMain ChassisHD501HD503

4HD500 Series(2) Parts [HD501, HD503]13 X Motherboard/ PSU Bolts2 × mATX Standoffs1 X Clamp10 X Cable Ties1 X User’s Manual1 X Lock Plate Bolt 1 X Lo

English5HD500 Series4①②③④⑤⑥⑦⑧⑨⑩① LCD & IR Receiver ② Power Button③ Power LED④ Reset Button⑤ HDD LED⑥ Media Control Button⑦ Volume Control Knob⑧ Fr

56HD500 SeriesInstallation(1) Installation Preparation1) Unfasten the rear screws and remove the Top Panel.2) Unfasten the two screws (Top and Side)

English7HD500 Series3) Unfasten the HDD Chassis’ Handscrew (Top) and Fixing Screw (Bottom) ,then move sequentially in the directions as indicated by